AMS 500 boost controller

[Dan.J]

http://psychobike.com/cgi-bin/ikonboard.cgi?s=28afd9084a94012a173e7718accd3255;act=ST;f=39;t=55115
there is a PDF file at the bottom of that page, shows wiring and connections. im good at mechanincs but terrible at wiring and such, anyone set one of these up or that can take a few minutes and put the wiring/hookup of this in laymans terms i picked one of these up and am about ready to start setting it up

[Chris Horoho]

what exactly do you need to know?

ill have a look and see what you need

[Dan.J]

guess that didnt work cant really read it

[Dan.J]

what exactly do you need to know?

ill have a look and see what you need

Pinky, i dont really understand how this thing gets wired, that graph is all u get and im sure its easy but ive never hooked one up, not sure how its activated/switched ect. im really considering only running the 2nd. stage of this and just getting the ramp up feature to work well. i would think it would be better on the motor to go to higher boost progessivly than BAM high boost. planning to go from 9/10#'s to 14/15#'s. i need to get some secondary injection freaking FMU limits ya too much....but its not in the budget at the moment.

[Chris Horoho]

you switch it by grounding/or adding 12+ to the input 1 or 2
just by using a switch to one of the 2 inputs
its a simple design and easy to wire
any help i can do i will

[Dan.J]

thanks man....appreciate it,ill be in touch

[BLACK_DEATH]